Mobi Fever Track Thermometer: Setup & Troubleshooting Guide

Welcome to the Mobi Fever Track Thermometer setup and troubleshooting guide! This article is designed to help you get your thermometer set up and answer some of the most common questions.

How to Change from °F to °C

Switching between Fahrenheit and Celsius is easy:

1. Press and hold the 'MEM/SET' button for 2 seconds.

2. The display will show the change from °F to °C (or vice versa).

3. Repeat the steps to toggle back if needed.

How to Change the Temperature Reading Mode (Forehead, Ear, Object/Surface)

To switch between measurement modes:

1. Press the 'MODE' button on the left-hand side of the device. You’ll see the icon at the top of the screen change as you cycle through the modes.

2. The available modes are:

   • Forehead (with probe cover in place)

   • Ear (remove the probe cover)

   • Object/Surface (baby bottle symbol)

Once the desired mode is displayed, press the 'SCAN' button to take a measurement.

• Forehead Measurement: Ensure the probe cover is in place. Place the probe on the center of the forehead (between the eyebrows and hairline). Press 'SCAN' to record the measurement. The thermometer will beep when done.

• Ear Measurement: Remove the probe cover, insert the probe slightly into the ear canal, and press 'SCAN'. The thermometer will beep once the temperature is recorded.

• Object/Surface Measurement: Remove the probe cover and hold the thermometer about 1 cm (1/2 inch) away from the object. Press 'SCAN' while aiming the probe at the object. The thermometer will beep when the temperature is recorded.

How to View the Memory

To view previous temperature readings:

1. From the home screen, press the 'MEM/SET' button.

2. The thermometer will beep three times and display the saved memory number and recording information.

3. Memory No. will show the most recent measurement. Press 'SET' again to cycle through previous readings.

How to Set HealthCheck Reminders

To set a countdown reminder for healthchecks:

1. Press the 'MEM/SET' and 'MODE' buttons together for 2 seconds to enter the countdown settings.

2. Use the 'MODE' button to toggle between 15 minutes, 30 minutes, 45 minutes, or OFF.

3. Press the 'MEM/SET' button when your desired time is displayed to start the countdown. While the countdown is active, the clock icon will flash on the screen.

4. To view the remaining time, press the 'MEM/SET' and 'MODE' buttons together for 2 seconds.

5. Once the countdown reaches zero, the health check symbol will appear and the thermometer will beep as a reminder.

6. Press any button to stop the reminder and return to the home screen.