We hope you are enjoying the simplicity and practicality of the Mobi Non-Contact Thermometer. This article has been created to assist you with setup and answer the most common troubleshooting questions.
Inserting the Batteries
For this device, the batteries go into the handle facing opposite directions. The battery to the rear of the handle goes in with the negative end first, positive facing upwards. The second battery to the front of the handle nearer the trigger goes the opposite, positive first, negative pointing upwards. Close the compartment and ensure it seals shut. Press the trigger button and the device will turn on.
Having trouble? View an additional the help article here.
How to change the temperature reading mode (Body or Surface)
The Non-Contact Thermometer has two temperature modes, "Body" and "Surface". To toggle between these modes, simply press the 'mode' button located on the right-hand side of the thermometer.
Body mode: Use this mode when taking body or forehead temperatures. Hold the device 0.4 - 2 inches from the forehead or body and press the trigger. The device will 'beep' three times to signify that the measurement is complete.
Surface mode: Use this mode to measure a room, surface, or object temperatures. Hold the device 0.4 - 2 inches from the forehead or body and press the trigger. The device will 'beep' three times to signify that the measurement is complete.
How to view the memory
The Non-Contact Thermometer will save the previous 50 measurements. You can cycle through these readings by pressing the 'memo' button once for each previous measurement you want to view. Keep track of the number onscreen to track which reading you are viewing. when you are done simply press the 'mode' button to return to the normal mode.
For a link to the instruction manual, please go here: https://www.getmobi.com/pages/user-manuals
Comments
0 comments
Article is closed for comments.